DatasheetsPDF.com

AC05DSMA Dataheets PDF



Part Number AC05DSMA
Manufacturers NEC
Logo NEC
Description (AC05DSMA / AC05FSMA) 5 A RESIN INSULATION TYPE TRIAC
Datasheet AC05DSMA DatasheetAC05DSMA Datasheet (PDF)

DATA SHEET AC05DSMA,AC05FSMA 5 A RESIN INSULATION TYPE TRIAC THYRISTORS DESCRIPTION The AC05DSMA and AC05FSMA are resin insulation type TRIACs with an effective current of 5 A (TC = 99°C). These products are covered with resin mold on the entire case and are electrically insulated with electrodes, giving them a 17 ±0.2 PACKAGE DRAWING (Unit: mm) 10.5 MAX. 7 ±0.2 4.7 MAX. φ 3.2 ±0.2 5 ±0.1 3.0 MAX. 2.8 ±0.2 considerable advantage over conventional TRIACs when mounting on a heatsink board .

  AC05DSMA   AC05DSMA


Document
DATA SHEET AC05DSMA,AC05FSMA 5 A RESIN INSULATION TYPE TRIAC THYRISTORS DESCRIPTION The AC05DSMA and AC05FSMA are resin insulation type TRIACs with an effective current of 5 A (TC = 99°C). These products are covered with resin mold on the entire case and are electrically insulated with electrodes, giving them a 17 ±0.2 PACKAGE DRAWING (Unit: mm) 10.5 MAX. 7 ±0.2 4.7 MAX. φ 3.2 ±0.2 5 ±0.1 3.0 MAX. 2.8 ±0.2 considerable advantage over conventional TRIACs when mounting on a heatsink board or performing high-density mounting. These products features ratings and electrical characteristics equal to TO-220AB package TRIAC and a high reliability design. 12 ±0.2 1 2 3 * FEATURES • Insulation type TRIAC fully covered with resin on the entire case other than electrode leads • Insulation voltage and conduction equal to conventional mica and polyester film • Can be replaced with TO-220AB package • High allowable on-current when using a single unit 0.8 ±0.1 2.54 TYP. 1.3 ±0.2 1.5 ±0.2 2.54 TYP. 13.5 MIN. 5 ±0.2 0.5 ±0.1 2.5 ±0.1 TRIAC 1: T1 2: T2 3: Gate APPLICATIONS *: TC test bench-mark Standard weight: 2 g Non-contact switches of motor speed control, heater temperature control, lamp light control The information in this document is subject to change without notice. Before using this document, please confirm that this is the latest version. Not all products and/or types are available in every country. Please check with an NEC Electronics sales representative for availability and additional information. Document No. D15293EJ4V0DS00 (4th edition) Date Published June 2004 NS CP(K) Printed in Japan The mark shows major revised points. 2002 AC05DSMA,AC05FSMA MAXIMUM RATINGS Parameter Non-repetitive Peak Off-state Voltage Repetitive Peak Off-state Voltage Effective On-state Current Surge On-state Current Symbol VDSM VDRM IT(RMS) ITSM AC05DSMA 500 400 5 (TC = 99°C) 50 (50 Hz 1 cycle) 55 (60 Hz 1 cycle) Fusing Current Critical Rate Rise of On-state Current Peak Gate Power Dissipation Average Gate Power Dissipation Peak Gate Current Junction Temperature Storage Temperature AC05FSMA 700 600 Unit V V A A Remarks − − Refer to Figure 11 and 12. Refer to Figure 2. ∫ iT2dt dIT/dt PGM PG(AV) IGM Tj Tstg 10 (1 ms ≤ t ≤ 10 ms) 50 3 (f ≥ 50 Hz, Duty ≤ 10%) 0.3 ±1.5 (f ≥ 50 Hz, Duty ≤ 10%) −40~+125 −55~+150 As A/µs W W A °C °C 2 − − − − − − − ELECTRICAL CHARACTERISTICS (Tj = 25°C) Parameter Repetitive Peak Off-state Current Symbol IDRM Conditions VDM = VDRM Tj = 25°C Tj = 125°C On-state Voltage Gate Trigger Current Mode I II III IV Gate Trigger Voltage Mode I II III IV Gate Non-trigger Voltage Holding Current Critical Rate Rise of Off-state Voltage Commutating Critical Rate Rise of Off-state Voltage Thermal Resistance Note MIN. − − − TYP. − − − − − − − − − − − − 10 100 − MAX. 100 1 1.8 10 − 10 10 1.5 − 1.5 1.5 − − − − Unit Remarks − − Refer to Figure 1. Refer to Figure 4. µA mA V mA VTM IGT ITM = 5 A VDM = 12 V, RL = 30 Ω T2+, G+ T2−, G+ T2−, G− T2+, G− − − − − − − − − 0.2 − VGT VDM = 12 V, RL = 30 Ω T2+, G+ T2−, G+ T2−, G− V Refer to Figure 4. VGD IH dv/dt T2+, G− Tj = 125°C, VDM = 1 VDRM 2 V mA V/µs V/µs − − − − VDM = 24 V Tj = 125°C, VDM 2 = 3 VDRM − 5 (dv/dt)c Tj = 125°C, (diT/dt)c = −2.7 A/ms, VD = 400 V Rth(j-c) Junction-to-case AC − − 4.2 °C/W Refer to Figure 13. Note The thermal resistance with a 50 Hz or 60 Hz sine wave current, as shown in the following expression: Rth(j-c) = Tj (max) − TC PT ( AV ) Tj(max): Maximum junction temperature TC: Case temperature PT(AV): Average on-dissipation 2 Data Sheet D15293EJ4V0DS AC05DSMA,AC05FSMA TYPICAL CHARACTERISTICS Figure 1. iT vs. νT CHARACTERISTIC 100 50 MAX. Figure 2. ITSM RATING 140 Initial Tj = 125˚C ITSM 0 π N=1 2 ITSM - Surge On-state Current - A iT - On-state Current - A 120 100 80 60 40 20 0 60 Hz 50 Hz 10 5 TC = 125˚C 25˚C 1.0 0.5 0.1 0 1 2 3 4 5 1 5 10 50 100 νT - On-state Voltage - V Cycles - N Figure 3. GATE RATING 10 Tj = −40 to +125˚C Figure 4. GATE CHARACTERISTIC 2.5 Mode I, III, IV 8 VGT - Gate Trigger Voltage - V VG - Gate Voltage - V 2 6 1.5 −40˚C 4 PG = 3 W f ≥ 50 Hz Duty ≤ 10% 1 25˚C 125˚C 2 PG(AV) = 0.3 W IGM 0.5 0 0 0.5 1.0 1.5 2.0 2.5 3.0 0 0 10 20 30 40 50 IG - Gate Current - A IGT - Gate Trigger Current - mA Figure 5. IGT vs. TA CHARACTERISTIC 100 Mode I, III, IV Figure 6. VGT vs. TA CHARACTERISTIC 1.4 Mode I, III, IV IGT - Gate Trigger Current - mA VGT - Gate Trigger Voltage - V 1.2 1.0 0.8 0.6 0.4 0.2 0 10 1 0.1 −40 0 40 80 120 −40 0 40 80 120 160 TA - Ambient Temperature - °C TA - Ambient Temperature - °C Data Sheet D15293EJ4V0DS 3 AC05DSMA,AC05FSMA Figure 7. iGT vs. τ CHARACTERISTIC 1000 Mode I, III, IV TA = 25˚C Figure 8. νGT vs. τ CHARACTERISTIC 5 Mode I, III, IV TA = 25˚C iGT - Gate Trigger Current - mA νGT - Gate Trigger Voltage - V 4 100 3 10 2 1 1 0.1 1 10 100 1000 0 1 10 100 1000 τ - Pulse Width - µs τ - Pulse.


KE924505 AC05DSMA AC05FSMA


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site.
(Privacy Policy & Contact)