PM25LV512

PMC FEATURES • Single Power Supply Operation - Low voltage range: 2.7 V - 3.6 V Memory Organization - Pm25LV512: 64K x 8 (512 Kbit) - Pm25LV010: 128K x 8 (1 Mbit) • Cost Effective Sector/Block Architecture - Uniform 4 Kbyte sectors - Uniform 32 Kbyte blocks (8 sectors per block) - Two blocks with 32 Kbytes each (512 Kbit) - Four blocks with 32 Kbytes each (1 Mbit) - 128 pages per block Pm25LV512 / Pm25LV010 512 Kbit / 1 Mbit 3.0 Volt-only, Serial Flash Memory With 25 MHz SPI Bus Interface • Block Write Protection - The Block Protect (BP1, BP0) bits allow part or entire of the memory to be configured as read-only. • Hardware Data Protection - Write Protect (WP#) pin will inhibit write operations to the status register Page Program (up to 256 Bytes) - Typical 2 ms per page program time • Serial Peripheral Interface (SPI) Compatible - Supports SPI Modes 0 (0,0) and 3 (1,1) • High Performance Read - 25 MHz clock rate (maximum) • Page Mode for Program Operations - 256 bytes per page GENERAL DESCRIPTION The Pm25LV512/010 are 512 Kbit/1 Mbits 3.0 Volt-only serial Flash memories. These devices are designed to use a single low voltage, range from 2.7 Volt to 3.6 Volt, power supply to perform read, erase and program operations. The devices can be programmed in standard EPROM programmers as well. The device is optimized for use in many commercial applications where low-power and low-voltage operation are essential. The Pm25LV512/010 is enabled through the Chip Enable pin (CE#)...