UGN3175

3175 AND 3177 HALL-EFFECT LATCHES These Hall-effect latches are temperature-stable and stress-resistant sensors especially suited for electronic commutation in brushless dc motors using multipole ring magnets. Each device includes a voltage regulator, quadratic Hall voltage generator, temperature compensation circuit, signal amplifier, Schmitt trigger, and an open-collector output on a single silicon chip. The on-board regulator permits operation with supply voltages of 4.5 volts to 18 volts. The switch output can sink 10 mA. With suitable output pull up, they can be used directly with bipolar or MOS logic circuits. The three package styles available provide a magnetically optimized package for most applications. Suffix ‘LT’ is a surface-mount SOT-89/ TO-243AA package; suffixes ‘U’ and ‘UA’ feature wire leads for through-hole mounting. Data Sheet 27609.4A V X CC 1 2 3 GROUND OUTPUT SUPPLY FEATURES I Symmetrical Response I 4.5 V to 18 V Operation I Open-Collector Output I Reverse Battery Protection I Activate With Small, Commercially Available Permanent Magnets I Solid-State Reliability I Small Size I Superior Temperature Stability I Resistant to Physical Stress Dwg. PH-003A Pinning is shown viewed from branded side. ABSOLUTE MAXIMUM RATINGS Supply Voltage, VCC . . . . . . . . . . . . . 18 V Reverse Battery Voltage, VRCC . . . . -18 V Magnetic Flux Density, B . . . . Unlimited Output OFF Voltage, VOUT . . . . . . . . 18 V Continuous Output Current, IOUT . 15 mA O...