8/16-BIT SINGLE VOLTAGE FLASH MCU FAMILY WITH RAM / E3 TMEMULATED EEPROM / CAN 2.0B AND J1850 BLPD
ST92F124/ST92F150/ST92F250
8/16-BIT SINGLE VOLTAGE FLASH MCU FAMILY WITH RAM, E3 TM(EMULATED EEPROM), CAN 2.0B AND J1850...
Description
ST92F124/ST92F150/ST92F250
8/16-BIT SINGLE VOLTAGE FLASH MCU FAMILY WITH RAM, E3 TM(EMULATED EEPROM), CAN 2.0B AND J1850 BLPD
PRELIMINARY DATA
s
Memories
– Internal Memory: Single Voltage FLASH up to 256 Kbytes, RAM up to 8Kbytes, 1K byte E3 TM (Emulated EEPROM) – In-Application Programming (IAP) – 224 general purpose registers (register file) available as RAM, accumulators or index pointers
TQFP64
14x14
PQFP100
14x20
s
Clock, Reset and Supply Management
– Register-oriented 8/16 bit CORE with RUN, WFI, SLOW, HALT and STOP modes – 0-24 MHz Operation (Int. Clock), 4.5-5.5 V range – PLL Clock Generator (3-5 MHz crystal) – Minimum instruction time: 83 ns (24 MHz int. clock) 80, 77 or 48 I/O pins (depending on device)
TQFP100
14x14 – One Multiprotocol Serial Communications Interface with asynchronous and synchronous capabilities – One asynchronous Serial Communications Interface (on 100-pin versions only) with 13-bit LIN Synch Break generation capability – J1850 Byte Level Protocol Decoder (JBLPD) (on F150J versions only) – One or two full I²C multiple Master/Slave Interfaces supporting Access Bus – One or two CAN 2.0B (150 version only) Active interfaces 10-bit Analog to Digital Converter allowing up to 16 input channels on 100-pin devices or 8 input channels on 64-pin devices
s s
Interrupt Management
– 80, 77 or 48 I/O pins (depending on device) – 4 external fast interrupts + 1 NMI – Up to 16 pins programmable as wake-up or additional external interrupt with multi-level ...
Similar Datasheet