SANYO INVERTER POWER HYBRID MODULE
SIP Full Molded Package
TENTATIVE
IGBT 600V/10A High Speed
STK621-015
1. Overview...
SANYO INVERTER POWER HYBRID MODULE
SIP Full Molded Package
TENTATIVE
IGBT 600V/10A High Speed
STK621-015
1. Overview: This IC is a 3-phase Inverter power hybrid IC containing power elements (IGBT and FRD), pre-driver, over-current protection circuit. 2. Application: 3-phase Inverter Motor. Induction Motor. Blushless-DC Motor 3. Features: Integrates power elements (IGBT and FRD), pre-driver, and protective circuit. Protective circuits including over-current (bus line), and pre-drive low voltage protection are built in. Direct input of CMOS level control signals without an insulating circuit (photo-coupler, etc) is possible. A single power supply drive is enabled through the use of bootstrap circuits for upper power supplies. (externally set) Built-in simultaneous upper/lower ON prevention circuit to prevent arm shorting through simultaneous ON input for the upper and lower side
transistors. (Dead time is required for preventing shorting due to switching delay.) SIP (The single in-line package) of the transfer full mold structure. 4. Absolute maximum ratings at ‚s c=25Ž
Parameter Supply voltage Collector-emitter voltage Output current Output peak current Pre-driver supply voltage Input signal voltage FAULT terminal voltage Maximum loss Junction temperature Storage temperature Operating temperature Symbol VCC VCE IO IOP VD1,2,3,4 VIN VFAULT Pd Tj Tstg TC Ratings 500 600 } 10 } 15 20 0 to 7 20 15 150 Ž Ž Ž H-IC case temperature -40 to +125 -20 to +100 Unit V...