SINGLE OUTPUT
DGP30 SERIES
SINGLE OUTPUT
DESCRIPTION The single output DGP30 Series is designed to accept an extended 2:1 input voltag...
Description
DGP30 SERIES
SINGLE OUTPUT
DESCRIPTION The single output DGP30 Series is designed to accept an extended 2:1 input voltage range for use in industrial and telecom applications. The output of the converter is electrically isolated, thereby allowing the output to be configured as a positive or negative output voltage. For additional system utility output Trim and Remote ON/OFF are featured. Overcurrent protection, overtemperature protection, and output overvoltage transient protection allow safe, reliable operation. FEATURES Remote ON/OFF and TRIM Low OFF Current Overcurrent and Overtemperature Protection Efficiencies to 86% Transient Output Overvoltage Protection 1544V Isolation Five-Side Shielded Case Extended Range Input (2:1)
BOTTOM VIEW 2.02 (51.31) SIDE VIEW 0.040 (1.02) DIA 6 PLACES
0.700 (17.78) 0.600 (15.24) 0.400 (10.16) 0.300 (7.62) 0.000 0.100 (2.54) 0.31 (7.9) 0.11 (2.8) 0.000
5 1 2 6 1.62 (41.15)
3
7
0.3 (7.62)
1.800 (45.72)
Mechanical tolerances unless otherwise noted: X.XX dimensions: ±0.020 inches X.XXX dimensions: ±0.005 inches
NOTES (1) All parameters measured at Tc = 25°C, nominal input voltage and full rated load unless otherwise noted. Refer to the Technical Reference Section for the definition of terms, measurement circuits and other information. (2) ON/OFF pin is referenced to pin 2, -Input. See DGP30 Series Application Notes for the specific requirements of this feature. (3) The Case is electrically connected to Pin 1, +Input. (4)...
Similar Datasheet