MCP2510

MCP2510 Stand-Alone CAN Controller with SPI® Interface FEATURES Implements Full CAN V2.0A and V2.0B at 1 Mb/s - 0 - 8 byte message length - Standard and extended data frames - Programmable bit rate up to 1 Mb/s - Support for remote frames - Two receive buffers with prioritized message storage - Six full acceptance filters - Two full acceptance filter masks - Three transmit buffers with prioritization and abort features - Loop-back mode for self test operation Hardware Features - High Speed SPI Interface (5 MHz at 4.5V I temp) - Supports SPI modes 0,0 and 1,1 - Clock out pin with programmable prescaler - Interrupt output pin with selectable enables - ‘Buffer full’ output pins configureable as interrupt pins for each receive buffer or as general purpose digital outputs - ‘Request to Send’ input pins configureable as control pins to request immediate message transmission for each transmit buffer or as general purpose digital inputs - Low Power Sleep mode Low power CMOS technology - Operates from 3.0V to 5.5V - 5 mA active current typical - 10 µA standby current typical at 5.5V 18-pin PDIP/SOIC and 20-pin TSSOP packages Temperature ranges supported: -40°C to +85°C - Industrial (I): -40°C to +125°C - Extended (E): DESCRIPTION The Microchip Technology Inc. MCP2510 is a Full Controller Area Network (CAN) protocol controller implementing CAN specification V2.0 A/B. It supports CAN 1.2, CAN 2.0A, CAN 2.0B Passive, and CAN 2.0B Active versions of the protocol, and is capable...