VOLTAGE CONTROLLED SAW OSCILLATOR
Integrated Circuit Systems, Inc.
Product Brief
M630
VOLTAGE CONTROLLED SAW OSCILLATOR
PIN ASSIGNMENT (1.6 x 1.8 inch ...
Description
Integrated Circuit Systems, Inc.
Product Brief
M630
VOLTAGE CONTROLLED SAW OSCILLATOR
PIN ASSIGNMENT (1.6 x 1.8 inch SMA)
M 630
G lass F eed Thru VT GND G lass F eed T hru VCC
GENERAL DESCRIPTION
The M630 is a VCSO (Voltage Controlled SAW Oscillator) frequency source for low-jitter clock generation. Its integrated SAW (surface acoustic wave) based oscillator and filters deliver output with exceptionally low phase jitter. The M630 is available in a selection of center frequencies in the 10GHz range. The M630 is suitable for phase-locked loop implementations, clock and data recovery circuits, and other timing applications for the telecom and optical fiber networking markets (OC-192/STM-64 with and without Forward Error Correction - FEC).
Vt GND Vcc
SM A C onnector
RF
RF
FEATURES
VCSO center frequencies from 9.953 to 12.249 GHz
(Specify center frequency at time of order) Low phase noise -65dBc/Hz @ 1kHz offset Single 6.5V power supply Small 1.6 x 1.8 inch SMA connector package Sample of Available Output Frequencies
VCSO Center Frequency1 (GHz) 9.953 GHz 10.664 GHz 12.249 GHz Applications OC-192 OC-192, OTU2 FEC OC-192 FEC
1. Specify VCSO center frequency at time of order
BLOCK DIAGRAM
M630
SAW Delay Line
Phase Shifter
2x Frequency Multiplier
Bandpass Filter
4x Frequency Multiplier
Bandpass Filter
RF_OUT
RF Amp
VT
M630 Rev 1.1
M630 Voltage Controlled SAW Oscillator
Revised 14Nov2003
●
Integrated Circuit Systems, Inc.
Communications Modules
●
w w w....
Similar Datasheet