INTEGRATED CIRCUITS
DATA SHEET
TDA3609JR Multiple voltage regulator with switch and ignition buffers
Preliminary speci...
INTEGRATED CIRCUITS
DATA SHEET
TDA3609JR Multiple voltage
regulator with switch and ignition buffers
Preliminary specification File under Integrated Circuits, IC01 1997 Aug 15
Philips Semiconductors
Preliminary specification
Multiple voltage
regulator with switch and ignition buffers
FEATURES General Extreme low noise behaviour and good stability with very small output capacitors Two VP-state controlled
regulators (
regulator 1 and
regulator 3) and a power switch
Regulator 2, reset and ignition buffer operate during load dump and thermal shutdown Separate control pins for switching
regulator 1,
regulator 3 and the power switch Supply voltage range of −18 to +50 V Low reverse current of
regulator 2 Low quiescent current (when
regulator 1,
regulator 3, and power switch are switched-off) Hold output (only valid when
regulator 1 is switched-on) Reset and hold outputs (open collector outputs) Adjustable reset delay time High ripple rejection Back-up capacitor for
regulator 2 Two independent ignition buffers (one inverted and with open collector output). Protections Reverse polarity safe (down to −18 V without high reverse current) Able to withstand voltages up to 18 V at the outputs (supply line may be short-circuited) ESD protected on all pins Thermal protections with hysteresis Load dump protection Foldback current limit protection for
regulators 1, 2 and 3 Delayed second current limit protection for the power switch (at short-circuit) ...