Decoder For Remote Controller With Five Functions
UTC RCR02
Decoder For Remote Controller With Five Functions
DESCRIPTION
The chip can be used with the encoder RCT02 to p...
Description
UTC RCR02
Decoder For Remote Controller With Five Functions
DESCRIPTION
The chip can be used with the encoder RCT02 to provide a complete control functions to the remote-controlled toy. The RCR02 has five output pins corresponding with the five function actions i.e, forward, backward, rightward, leftward and turbo. The received signals are amplified by the three-stage amplifier, and then the appropriate amplified signals are sampled, fault-tolerantly checked and decoded to control the actions of the remote-controlled toy. There is an internal oscillator in the RCR02.By adding an external resistor conveniently, the oscillator will be constructed. The oscillator frequency can be adjusted by the external resistor.The relative error between the frequencies of the two on chip oscillators in the RCT02 and RCR02 must be less than ±25%.
CMOS IC
SOP-16
DIP-16
FEATURES
*Five output pins for control functions *Operating power-supply voltage range: 2.5 to 5.0V *On-chip reversing amplifiers *On-chip oscillator with an external resistor *Low operating current *Few external components needed
LOGIC BLOCK DIAGRAM
OSCI Oscillator OSCO
Timing Generator
RIGHT Latch Output Circuit LEFT TURBO FORWARD BACKWARD
SI
Amp
Signal Sample and FaultTolerant Check VO1
Decoding Circuit
VI1
Amp
VI2
Amp
VO2
Control Logic
LDB RDB
UTC
UNISONIC TECHNOLOGIES CO., LTD.
1
QW-R502-001,B
UTC RCR02
PRODUCT PIN CONFIGURATION AND DESCRIPTION
VO2 GND SI OSCI OSCO RIGHT LEFT RDB 1 2 3 4 5 6 7 8 16 15...
Similar Datasheet