SPI Serial E2PROM With Block LockTM Protection
APPLICATION NOTE
A V A I L A B L E
X25080 8K
AN61
X25080
SPI Serial E2PROM With Block LockTM Protection
DESCRIPTION
...
Description
APPLICATION NOTE
A V A I L A B L E
X25080 8K
AN61
X25080
SPI Serial E2PROM With Block LockTM Protection
DESCRIPTION
1K x 8 Bit
FEATURES
2MHz Clock Rate SPI Modes (0,0 & 1,1) 1K X 8 Bits — 32 Byte Page Mode Low Power CMOS — <1µA Standby Current — <5mA Active Current 2.7V To 5.5V Power Supply Block Lock Protection — Protect 1/4, 1/2 or all of E2PROM Array Built-in Inadvertent Write Protection — Power-Up/Power-Down protection circuitry — Write Enable Latch — Write Protect Pin Self-Timed Write Cycle — 5ms Write Cycle Time (Typical) High Reliability — Endurance: 100,000 cycles — Data Retention: 100 Years — ESD protection: 2000V on all pins 8-Lead PDlP Package 8-Lead SOIC Package 14-Lead TSSOP Package FUNCTIONAL DIAGRAM
STATUS REGISTER WRITE PROTECT LOGIC
The X25080 is a CMOS 8192-bit serial E2PROM, internally organized as 1K x 8. The X25080 features a Serial Peripheral Interface (SPI) and software protocol allowing operation on a simple three-wire bus. The bus signals are a clock input (SCK) plus separate data in (SI) and data out (SO) lines. Access to the device is controlled through a chip select (CS) input, allowing any number of devices to share the same bus. The X25080 also features two additional inputs that provide the end user with added flexibility. By asserting the HOLD input, the X25080 will ignore transitions on its inputs, thus allowing the host to service higher priority interrupts. The WP input can be used as a hardwire input to the X25...
Similar Datasheet