Switch Mode Power Supply with Multiple Linear Regulators and High Speed CAN Transceiver
Order this document from Analog Marketing Rev. 2.5, 11/2002
Switch Mode Power Supply with Multiple Linear Regulators an...
Order this document from Analog Marketing Rev. 2.5, 11/2002
Switch Mode Power Supply with Multiple Linear
Regulators and High Speed CAN Transceiver
The 33394 is a multi–output power supply integrated circuit with high speed CAN transceiver. The IC incorporates a switching pre–
regulator operating over a wide input voltage range from +4.0V to +26.5V (with transients up to 45V). The switching
regulator has an internal 3.0A current limit and runs in both buck mode or boost mode to always supply a pre–regulated output followed by Low Drop Out (LDO)
regulators: VDDH / 5.0V @ 400mA; VDD3_3 / 3.3V @ 120mA; VDDL / 2.6V (User scalable between 3.3V – 1.25V) @ 400mA typically, using an external
NPN pass
transistor. The Keep Alive
regulator VKAM (scalable) @ 50mA; FLASH memory programming voltage VPP / 5.0V or 3.3V @ 150mA; three sensor supply outputs VREF(1,2,3) / 5.0V (tracking VDDH) @ 100mA each; and a switched battery output (VSEN) to supply 125mA clamped to 17V. Additional features include Active Reset circuitry watching VDDH, VDD3_3, VDDL and VKAM, user selectable Hardware Reset Timer (HRT), Power Sequencing circuitry guarantees the core supply voltages never exceed their limits or polarities during system power up and power down. A high speed CAN transceiver physical layer interfaces between the microcontroller CMOS outputs and differential bus lines. The CAN driver is short circuit protected and tolerant of loss of battery or ground conditions. 33394 is designed specifically to m...