4 Mbit 512Kb x8 or 256Kb x16 UV EPROM and OTP EPROM
M27V400
4 Mbit (512Kb x8 or 256Kb x16) UV EPROM and OTP EPROM
NOT FOR NEW DESIGN
s s
M27V400 is replaced by the M27W400...
Description
M27V400
4 Mbit (512Kb x8 or 256Kb x16) UV EPROM and OTP EPROM
NOT FOR NEW DESIGN
s s
M27V400 is replaced by the M27W400 3V to 3.6V LOW VOLTAGE in READ OPERATION ACCESS TIME: 100ns BYTE-WIDE or WORD-WIDE CONFIGURABLE 4 Mbit MASK ROM REPLACEMENT LOW POWER CONSUMPTION – Active Current 30mA at 8MHz – Stand-by Current 20µA
40
40
s s
s s
1
1
FDIP40W (F)
PDIP40 (B)
s s s
PROGRAMMING VOLTAGE: 12.5V ± 0.25V PROGRAMMING TIME: 50µs/word ELECTRONIC SIGNATURE – Manufacturer Code: 20h – Device Code: B8h Figure 1. Logic Diagram
DESCRIPTION The M27V400 is an 4 Mbit EPROM offered in the two ranges UV (ultra violet erase) and OTP (one time programmable). It is ideally suited for microprocessor systems requiring large data or program storage. It is organised as either 512 Kwords of 8 bit or 256 Kwords of 16 bit. The pin-out is compatible with the most common 4 Mbit Mask ROM. The FDIP40W (window ceramic frit-seal package) has a transparent lid which allows the user to expose the chip to ultraviolet light to erase the bit pattern. A new pattern can then be written rapidly to the device by following the programming procedure. For applications where the content is programmed only one time and erasure is not required, the M27V400 is offered in PDIP40 package.
VCC
18 A0-A17 15
Q15A–1
Q0-Q14 E G BYTEVPP M27C400
VSS
AI01634
July 2000
This is information on a product still in production but not recommended for new designs.
1/14
M27V400
Figure 2. DIP Connections
A17 A7 A6 A5 A4 A3 A2 A1...
Similar Datasheet