ESD Protection Diode with Resistors
DS9503 ESD Protection Diode with Resistors
www.dalsemi.com
SPECIAL FEATURES
§ Zener characteristic with voltage snap–ba...
Description
DS9503 ESD Protection Diode with Resistors
www.dalsemi.com
SPECIAL FEATURES
§ Zener characteristic with voltage snap–back to protect against ESD hits § High avalanche voltage, low leakage and low capacitance avoid signal attenuation § Compatible to all 5V logic families § Space saving, low inductance TSOC surface mount package
SYMBOL AND CONVENTIONS
C IC VCA A
PACKAGE OUTLINE
TSOC SURFACE MOUNT PACKAGE
1
6 5 4 SIDE VIEW
§ On–chip 5Ω resistors for isolation at both anode and cathode terminals § Industrial temperature range
2 3
TOP VIEW 3.7 X 4.0 X 1.5 mm See Mech. Drawings Section
ORDERING INFORMATION
DS9503P 6-lead TSOC package
DESCRIPTION
This DS9503 is designed as an ESD protection device for 1–Wire MicroLAN interfaces. In contrast to the DS9502, the DS9503 includes two 5Ω isolation resistors on chip. Although 5Ω are negligible during communication, they represent a high impedance relative to the conducting diode during an ESD event. Thus, the diode absorbs the energy while the resistors further isolate and protect the circuit at the other side of the package. If used with circuits that already have a strong ESD–protection at their I/O port, the ESD protection level is raised to more that 27 kV (IEC 801–2 Reference model). In case of abnormal ESD hits beyond its maximum ratings the DS9503 will eventually fail “short” thus preventing further damage. During normal operation the DS9503 behaves like a regular 7.5V Zener Diode. When the voltage exceeds the trigger volt...
Similar Datasheet