Document
HMP8170, HMP8171, HMP8172, HMP8173
Data Sheet May 1999 File Number 4284.5
NTSC/PAL Video Encoder
The HMP8170, HMP8171, HMP8172, and HMP8173 NTSC and PAL encoders are designed for use in systems requiring the generation of high-quality NTSC and PAL video. YCbCr digital video data drive the P0-P15 inputs. The Y data is optionally lowpass filtered to 6MHz and drives the Y analog output. Cb and Cr are each lowpass filtered to 1.3MHz, quadrature modulated, and added together. The result drives the C analog output. The digital Y and C data are also added together and drive the two composite analog outputs. The DACs can drive doubly-terminated (37.5Ω) lines, and run at a 2x oversampling rate to simplify the analog output filter requirements.
Features
• (M) NTSC and (B, D, G, H, I, M, N, NC) PAL Operation • BT.601 and Square Pixel Operation • Digital Input Formats - 8-bit, 16-bit 4:2:2 YCbCr - 8-bit BT.656 • Analog Output Formats - Y/C + Two Composite - RGB + Composite - YUV + Composite • Flexible Video Timing Control - Timing Master or Slave - Selectable Polarity on Each Control Signal - Programmable Blank Output Timing • “Sliced” VBI Data Support - Closed Captioning - Widescreen Signalling (WSS) - BT.653 System B and C Teletext - NABTS (North American Broadcast Teletext) - WST (World System Teletext) • Four 2x Oversampling, 10-Bit DACs • Fast I2C Interface
Applications
• DVD Players • Video CD Players • Digital VCRs • Multimedia PCs
Related Products
• NTSC/PAL Encoders - HMP8154, HMP8156A • NTSC/PAL Decoders - HMP8115
Ordering Information
PART NUMBER HMP8170CN HMP8171CN HMP8172CN HMP8173CN (Note 1) (Note 1) MACROVISION v7.01 no yes no yes RGB / YUV OUTPUTS no no yes yes TEMP. RANGE (oC) 0 to 70 0 to 70 0 to 70 0 to 70 PACKAGE 64 Ld PQFP (Note 2) 64 Ld PQFP (Note 2) 64 Ld PQFP (Note 2) 64 Ld PQFP (Note 2) PKG. NO. Q64.14x14 Q64.14x14 Q64.14x14 Q64.14x14
HMP817xEVAL1 NOTES:
Daughter Card Evaluation Platform, where x is replaced by 0, 1, 2, or 3 (Note 3).
1. The HMP8171 and HMP8173 may be purchased by Macrovision Authorized Buyers only. These devices are protected by U.S. patent numbers 4,631,603, 4,577,216, and 4,819,098, and other intellectual property rights. The use of Macrovision’s copy protection technology in the devices must be authorized by Macrovision and is intended for home and other limited pay-per-view uses only, unless otherwise authorized in writing by Macrovision. Reverse engineering or disassembly is prohibited. 2. PQFP is also known as QFP and MQFP. 3. Evaluation board descriptions are in the Applications section.
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. Intercast™ is a trademark of Intel Corporation. http://www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999
P0 - P15
4:2:2 TO 4:4:4 SAMPLE CONVERSION
MACROVISION PROCESSING (HMP8171 AND HMP8173 ONLY) VBI DATA PROCESSING INTERNAL 1.195V REFERENCE
Functional Block Diagram
2
(OPTIONAL) LP FILTER Y DAC 2X UPSAMPLE (4:4:4 TO 8:8:8) LP FILTER Cb/Cr DAC DAC CHROMA MODULATION DAC FIELD
VREF FS ADJUST
SA
Y
SCL
HOST INTERFACE
SDA
RESET
NTSC/ PAL 1
HSYNC NTSC/ PAL 2
VSYNC
VIDEO
BLANK
TIMING
CONTROL C
HMP8170, HMP8171, HMP8172, HMP8173
CLK
CLK2
HMP8170, HMP8171, HMP8172, HMP8173 Functional Operation
The HMP8170 - HMP8173 are fully integrated digital encoders. All accept YCbCr digital video input data and generate analog video output signals. The four outputs are two composite video signals and Y/C (S-Video). The HMP8172 and HMP8173 can also be configured to output one composite and component RGB or YUV video. The HMP817x accepts pixel data in one of several formats and transforms it into 4:4:4 sampled luminance and chrominance (YCbCr) data. The encoder then interpolates the YCbCr data to twice the pixel rate and low pass filters it to match the bandwidth of the video output format. If enabled, the encoder also adds vertical blanking interval (VBI) information to the Y data. At the same time, the encoder modulates the chrominance data with a digitally synthesized subcarrier. Finally, the encoder outputs luminance, chrominance, and their sum as analog signals using 10-bit D/A converters. The HMP817x provides operating modes to support all versions of the NTSC and PAL standards and accepts full size input data with rectangular (BT.601) and square pixel aspect ratios. It operates from a single clock at twice the pixel clock rate determined by the operating mode. The HMP817x’s video timing control is flexible. It may operate as the master, generating the system’s video timing control signals, or it may accept external timing controls. The polarity of the timing controls and the number of active pixels and lines are programmable. The color difference signals are time multiplexed into one 8-bit bus beginning with a Cb sample. The Y and CbCr busses may be input in parallel (16-bit mode) or may be time multiplexed and input as a single bus (8-bit mode). Th.