320 mA Switched Capacitor Voltage Doubler
a
FEATURES Push-Pull Charge Pump Doubler Reduces Output Ripple +3.0 V to +3.6 V Operation V OUT > +5.4 V @ 320 mA Maximu...
Description
a
FEATURES Push-Pull Charge Pump Doubler Reduces Output Ripple +3.0 V to +3.6 V Operation V OUT > +5.4 V @ 320 mA Maximum Load Output Impedance, RTOTAL ≤ 1.66 ⍀ Shutdown Capability Overvoltage Protection: VIN > +4 V Operating Temperature Range: –20؇ C to +85؇ C Thermally Enhanced 16-Lead TSSOP Package APPLICATIONS High Current Doublers LCD Panels Cellular Phones Inductorless Boost Converters
VIN
320 mA Switched Capacitor Voltage Doubler ADP3610
FUNCTIONAL BLOCK DIAGRAM
CP1 CM1 CP2 CM2 VOUT
GND
DRV
DRV
ADP3610
DRIVE LOGIC OVERVOLTAGE PROTECTION
1MHz OSC
SD
GENERAL DESCRIPTION The ADP3610 is a push-pull switched-capacitor converter voltage doubler. The term “push-pull” refers to two charge pumps working in parallel and in opposing phase to deliver charge to support the output voltage. When one capacitor is pumping charge to the output, the other is recharging. This technique minimizes voltage loss and output voltage ripple. The converter accommodates input voltages from +3 V to +3.6 V and can provide 320 mA using 2.2 µF MLCC pump capacitors. Converter operation can be enabled or disabled simply by an input signal. The package is enhanced with Analog Devices’ proprietary Thermal Coastline feature, which allows up to 980 mW of power dissipation at room temperature. The exceptionally thin TSSOP-16 package and the requirement of only capacitors (no inductors) to support the converter operation allows slim designs, e.g., for TFT or LCD display panels.
CP1 2.2F
VIN CIN 1...
Similar Datasheet