SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR POWER 600 Watt
5 to 220 Volt
Recongnized File # E210467
• For surface mounted applications in order to optimize board space.
• Glass passivated junction
• Low inductance
• Plastic package has Underwriters Laboratory Flammability
• High temperature soldering : 260°C /10 seconds at terminals
• ESD IEC-61000-4-2 Air + 30kV, Contact + 30kV
• Lead free in compliance with EU RoHS 2011/65/EU directive
• Green molding compound as per IEC61249 Std. . (Halogen Free)
• Case: JEDEC DO-214AA,Molded plastic over passivated junction.
• Terminals: Solder plated,solderable per MIL-STD-750,Method 2026
• Polarity: Color band denotes cathode end
• Standard Packaging: 12mm tape (EIA-481)
• Weight: 0.003 ounce, 0.092 gram
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types P6SMBJ5.0 thru types P6SMBJ220.
Electrical characteristics apply in both directions.
MAXIMUM RATINGSAND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Peak Pulse Power Dissipation on tp=10/1000μs waveform (Notes 1,2, Fig.1)
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (Notes 2,3)
Peak Pulse Current on tp=10/1000μs waveform (Notes 1) Fig.3
see Table 1
Typical Thermal Resistance Junction to Air (Notes 2)
ESD IEC-61000-4-2 (Air)
ESD IEC-61000-4-2 (Contact)
Operating Junction and Storage Temperature Range
-55 to +150
OC / W
1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25OC per Fig. 2.
2. Mounted on 5mm2 (0.13mm thick) land areas.
3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum.
4. A transient suppressor is selected according to the working peak reverse voltage (VRWM), which should be equal to or
greater than the DC or continuous peak operating voltage level.
PAGE . 1