Document
DATA SHEET
Part No. Package Code No.
MN63Y1210
SSOP016-P-0225E
Publication date: February 2013
Ver. AEM
About this manual
Organization
These specifications provide important information for users of the MN63Y1210-E1, including an overview and descriptions of functions.
Manual Configuration
Each section of this manual consists of a title, main text, and notes. The layout and definition of each section are shown below.
1.1 UART
This section describes the UART specification.
1.1.1 Communication Specifications
Table 1-1 shows the UART specification of this RFID.
Table 1-1 UART Communication Specification
Data transfer method Data rate
Character transmission
Other
Asynchronous, half-duplex (Only IRQ notification allows full-
DUMMYduplex) 1200 bps, 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps
xLSB-first xData (8 bits) xStart bit (1bit) xParity bit (1bit, even) xStop bit (1bit) See Note below.
No flow control signal (RTS/CTS)
Middle title Small title
Text
Note: In order to ensure the timing margin, when sending consequtive data from the host, use a 2-bit stop bit or set the interval between stop bit and next start bit to 1 bit or more.
Note
This is the Note. Please read.
Finding Desired Information This manual provides two methods for finding desired information quickly and easily.
1. Consult the table of contents at the front of the manual to locate desired titles.
2. Chapter names are located at the top outer corner of each page, and section titles are located at the bottom outer corner of each page.
2
Chapter 1 Overview Chapter 2 Pin Descriptions Chapter 3 Memory Map Chapter 4 RF Communication Mode Chapter 5 Serial Communication Mode Chapter 6 Tunnel Mode Chapter 7 Electric Characteristics Chapter 8 Annex
1 2 3 4 5 6 7 8
Chapter 1 Overview
Contents
Chapter 1 Overview ................................................................... 7
1.1 Features..............................................................................................................................8 1.2 Block Diagram...................................................................................................................8 1.3 Operation Mode .................................................................................................................8
Chapter 2 Pin Descriptions........................................................ 8
2.1 List of Pins.........................................................................................................................8 2.2 Pin Descriptions.................................................................................................................8 2.3 Connection Example..........................................................................................................8
2.3.1 Using UART and 5 V Power.......................................................................................8 2.3.2 Using UART and 3 V Power.......................................................................................8 2.3.3 Using Clock Synchronous Mode and 5 V Power........................................................8 2.3.4 Using Clock Synchronous Mode and 3 V Power........................................................8
Chapter 3 Memory Map ............................................................. 8
3.1 Block Configuration ..........................................................................................................8 3.2 Physical Memory Map.......................................................................................................8 3.3 System Area.......................................................................................................................8
3.3.1 Parameter Specifications .............................................................................................8 3.3.2 Enabling System Area .................................................................................................8 3.4 Address Correspondence ...................................................................................................8
Chapter 4 RF Communication Mode ......................................... 8
4.1 RF Communication Mode Sequence .................................................................................8 4.2 JISX6319-4 Specification..................................................................................................8
4.2.1 Communication Specifications....................................................................................8 4.2.2 Frame Format ..............................................................................................................8 4.2.3 State Transition Diagram.............................................................................................8 4.2.4 Flow Chart...................................................................................................................8 4.2.5 Various Settings ..............................................