UDN2987x-6
DABIC-5 8-Channel Source Driver with Overcurrent Protection
Package A, 20-pin DIP
Package LW, 20-pin SOIC-W...
UDN2987x-6
DABIC-5 8-Channel Source Driver with Overcurrent Protection
Package A, 20-pin DIP
Package LW, 20-pin SOIC-W
Approximate Scale 1:1
Features
4.75 to 35 V driver supply
voltage Output enable-disable (OE/R) 350 mA output source current Overcurrent protected Internal ground clamp diodes Output Breakdown
Voltage 35 V minimum TTL, DTL, PMOS, or
CMOS compatible inputs Internal Thermal Shut Down (TSD)
Applications
Relays Motors Solenoids LEDs Incandescent lamps
Typical Application
CPU
IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8
FAULT OE/R¯
2987
OUT1 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 OUT8 GND
VS
1 to 8 Load Components
4.75 to 35 V
Providing overcurrent protection for each of its eight sourcing outputs, the UDN2987A-6 and UDN2987LW-6 drivers are used as an interface between standard low-level logic and relays, motors, solenoids, LEDs, and incandescent lamps. These devices include thermal shut down and output transient protection/clamp diodes for use with sustaining
voltages to 35 V.
In these drivers, each channel includes a latch to turn off that channel if the maximum channel current is exceeded. All channels are disabled if the thermal shutdown is activated. A common FAULT output is used to indicate either chip thermal shutdown or any overcurrent condition. All outputs are enabled by pulling the common OE/R input high. When OE/¯R is low, all outputs are inhibited and the eight latches are reset. The
www.DataSheet4U.com
OE/¯R function can be especially important during power-up...