PC PARALLEL PORT TO JTAG INTERFACE
®
ST20-JPI
PC PARALLEL PORT TO JTAG INTERFACE
PRODUCT INFORMATION
FEATURES • Desktop mounted parallel port to JTAG int...
Description
®
ST20-JPI
PC PARALLEL PORT TO JTAG INTERFACE
PRODUCT INFORMATION
FEATURES Desktop mounted parallel port to JTAG interface Standard 25 way D-type parallel port connection Standard 26 way D-type differential OS-Link port for connection to a B300. Standard 20 way IDC cable for JTAG connection. Plug top power supply Supports nibble, byte and EPP mode parallel port standards
DESCRIPTION The ST20-JPI parallel port to JTAG interface is a host interface to allow connection from a PC parallel port to any JTAG diagnostic controller based ST20 development board. The interface plugs into any standard PC 25 way D-type parallel port. Supported parallel port modes are:
Nibble mode Byte mode EPP mode
depending on which mode the host PC can support. Connection to the development target is via a 20 way IDC JTAG connector. Once connected, the development target can be accessed using the MS Windows drivers supplied with the standard ST20 toolset.
September 1996
1/10 42 1685 00
Contents
1 2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2.1 2.2 2.3 Hardware Installation - PC ..................................................................................................................... 4 Hardware Installation - B300 ............................
Similar Datasheet