SSC7150
Motion Coprocessor
Product Features
• High Performance 32-bit Embedded Controller • Low power 7.65mA (typ) in active mode • System in deep sleep consumes 70μA (typ) • 3.3-Volt I/O • Package
- 6mm x 6mm, 28-pin QFN
Sensor Firmware
• Sensor fusion firmware features include: - Self-contained 9-axis sensor fusion - Sensor data pass-through - Fast in-use background calibration of all sensors and calibration monitor - Magnetic immunity: Enhanced magnetic distortion detection and suppression -.
Motion Coprocessor
SSC7150
Motion Coprocessor
Product Features
• High Performance 32-bit Embedded Controller • Low power 7.65mA (typ) in active mode • System in deep sleep consumes 70μA (typ) • 3.3-Volt I/O • Package
- 6mm x 6mm, 28-pin QFN
Sensor Firmware
• Sensor fusion firmware features include: - Self-contained 9-axis sensor fusion - Sensor data pass-through - Fast in-use background calibration of all sensors and calibration monitor - Magnetic immunity: Enhanced magnetic distortion detection and suppression - Gyroscope drift cancellation
• Easy to implement complete turnkey sensor fusion solution
• Sensor power management • Sensors Supported
- Bosch BMC150 Geomagnetic Sensor/Accelerometer
- Bosch BMG160 Gyroscope
Hardware Features
The hardware features in the SSC7150 motion coprocessor include the following: • Two I2C Controllers
- Supports I2C bus speeds to 400kHz - Host Interface Supports Slave Operation - Sensor Interface Supports Master Operation • Low Power Modes
Target .