DatasheetsPDF.com

LM903 Datasheet

Part Number LM903
Manufacturers National Semiconductor
Logo National Semiconductor
Description Fluid Level Detector
Datasheet LM903 DatasheetLM903 Datasheet (PDF)

LM903 Fluid Level Detector February 1995 LM903 Fluid Level Detector General Description The LM903 uses the thermal-resistive probe technique to measure the level of nonflammable fluids A low fluid level is indicated by a warning lamp operating in continuous or flashing mode All supervisory requirements to control the thermal-resistive probe including short and open circuit probe detection are incorporated within the device The circuit has possible applications in the detection of hydraulic flu.

  LM903   LM903






Part Number LM9091BCT
Manufacturers TOPWAY
Logo TOPWAY
Description LCD Module User Manual
Datasheet LM903 DatasheetLM9091BCT Datasheet (PDF)

LM9091BCT LCD Module User Manual Prepared by: Li yinyang Date: 2015-12-08 Checked by: Date: Approved by: Date: Rev. Descriptions 0.1 Preliminary Release Date 2015-12-08 URL: www.topwaydisplay.com www.topwaysz.com Document Name: LM9091BCT-Manual-Rev0.1.DOC Page: 1 of 13 TOPWAY Table of Content LCD Module User Manual LM9091BCT 1. Basic Specifications . 3 1.1 Display Specifications. 3 1.2 Mechanical Specifications .... 3 1.3 Block Diagram.... 3 1.4 Terminal Functions. 4 2. Absolute Maxim.

  LM903   LM903







Part Number LM9076Q
Manufacturers Texas Instruments
Logo Texas Instruments
Description 150mA Ultra-Low Quiescent Current LDO Regulator
Datasheet LM903 DatasheetLM9076Q Datasheet (PDF)

LM9076Q www.ti.com SNVS713B – APRIL 2011 – REVISED MARCH 2013 LM9076Q 150mA Ultra-Low Quiescent Current LDO Regulator with Delayed Reset Output Check for Samples: LM9076Q FEATURES 1 •2 AEC-Q100 Grade1 Qualified (-40°C to +125°C) • Available with 5.0V or 3.3V Output Voltage • Ultra Low Ground Pin Current, 25 μA Typical for 100 μA Load • VOUT Initial Accuracy of ±1.5% • VOUT Accurate to ±3% Over Load and Temperature Conditions • Low Dropout Voltage, 200 mV Typical with 150 mA Load • Low Off St.

  LM903   LM903







Part Number LM9076
Manufacturers Texas Instruments
Logo Texas Instruments
Description 150mA Ultra-Low Quiescent Current LDO Regulator
Datasheet LM903 DatasheetLM9076 Datasheet (PDF)

LM9076 www.ti.com SNVS260L – NOVEMEBER 2003 – REVISED MARCH 2013 LM9076 150mA Ultra-Low Quiescent Current LDO Regulator with Delayed Reset Output Check for Samples: LM9076 FEATURES 1 •2 Available with 5.0V or 3.3V Output Voltage • Ultra Low Ground Pin Current, 25 μA Typical for 100 μA Load • VOUT Initial Accuracy of ±1.5% • VOUT Accurate to ±3% Over Load and Temperature Conditions • Low Dropout Voltage, 200 mV Typical with 150 mA Load • Low Off State Ground Pin current for LM9076BMA • Delaye.

  LM903   LM903







Part Number LM9076
Manufacturers National Semiconductor
Logo National Semiconductor
Description 150mA Ultra-Low Quiescent Current LDO Regulator with Delayed Reset Output
Datasheet LM903 DatasheetLM9076 Datasheet (PDF)

LM9076 - 150mA Ultra-Low Quiescent Current LDO Regulator with Delayed Reset Output December 2003 LM9076 150mA Ultra-Low Quiescent Current LDO Regulator with Delayed Reset Output General Description The LM9076 is a 5 Volt, +/-2%, 150mA logic controlled voltage regulator. The regulator features an active low delayed reset output flag which can be used to reset a microprocessor system at turn-ON and in the event that the regulator input voltage falls below a minimum value. An external capacitor p.

  LM903   LM903







Part Number LM9074
Manufacturers National Semiconductor
Logo National Semiconductor
Description System Voltage Regulator with Keep-Alive ON/OFF
Datasheet LM903 DatasheetLM9074 Datasheet (PDF)

LM9074 System Voltage Regulator with Keep-Alive ON/OFF Control PRELIMINARY January 2000 LM9074 System Voltage Regulator with Keep-Alive ON/OFF Control General Description The LM9074 is a 5V, 3% accurate, 180 mA NPN voltage regulator. The regulator features an active low delayed reset output flag which can be used to reset a microprocessor system on turn-ON and in the event that the regulator output falls out of regulation for any reason. An external capacitor programs a delay time interval bef.

  LM903   LM903







Fluid Level Detector

LM903 Fluid Level Detector February 1995 LM903 Fluid Level Detector General Description The LM903 uses the thermal-resistive probe technique to measure the level of nonflammable fluids A low fluid level is indicated by a warning lamp operating in continuous or flashing mode All supervisory requirements to control the thermal-resistive probe including short and open circuit probe detection are incorporated within the device The circuit has possible applications in the detection of hydraulic fluid oil level etc and may be used with partially conducting fluids Features Y Y Y Y Y Y Y Y Y Y Flashing or continuous warning indication Warning threshold externally adjustable Control circuitry for thermal-resistive probe Switch on reset and delay to avoid transients 600 mA flashing lamp drive capability Short and open circuit probe detection 70V transient protection on supply and control input 7V – 18V supply range Internally regulated supply b 40 C to a 80 C operation Connection Diagram Dual-In-Line Package TL H 5699 – 1 Order Number LM903N See NS Package Number N16E C1995 National Semiconductor Corporation TL H 5699 RRD-B30M115 Printed in U S A Absolute Maximum Ratings If Military Aerospace specified devices are required please contact the National Semiconductor Sales Office Distributors for availability and specifications Supply Voltage VCC Control Input Voltage (Pin 7) Transient Voltage (Pins 6 7 9) 10 ms (Note 1) Output Current (Pin 4) I4 (Sink) 18V 18V 70V 10 mA Operat.


2005-04-25 : M74LS73AP    C2719    STK0050    STK0050II    STK0080    MPQ2222    IRG4PH40K    IRG4PH40KD    IRG4PH40U    IRG4PH40UD   


@ 2014 :: Datasheetspdf.com ::
Semiconductors datasheet search & download site (Privacy Policy & Contact)