IMP1 832
POWER MANAGEMENT
3.3V µP Power Supply Monitor and Reset Circuit
Key Features
x Pin compatible with the Dallas...
IMP1 832
POWER MANAGEMENT
3.3V µP Power Supply Monitor and Reset Circuit
Key Features
x Pin compatible with the Dallas Semiconductor DS1832 — Over 40% lower supply current x 3.3V supply monitor x Push-pull output x Selectable watchdog period x Debounce manual push-button reset input x Precision temperature-compensated
voltage reference and comparator x Power-up, power-down and brownout detection x 250ms minimum reset time x Active LOW and HIGH reset signal x Selectable trip point tolerance: 10% or 20% x Low-cost 8-pin DIP/SO and 8-pin MicroSO packages x Wide operating temperature – 40°C to +85°C
– Selectable Trip -Point Tolerance and Watchdog Period – Push-Button Reset – Push-Pull Reset Outputs
The IMP1832 microprocessor supervisor can halt and restart a “hungup” or “stalled” microprocessor, restart a microprocessor after a power failure, and debounce a manual push-button microprocessor reset switch. The IMP1832 features over 40% lower supply current than the pin compatible Dallas Semiconductor DS1832.
Precision temperature compensated reference and comparator circuits monitor the 3.3V, VCC input
voltage. During power-up or when the VCC power supply falls outside selectable tolerance limits, both RESET and RESET become active. When VCC rises above the threshold
voltage, the reset signals remain active for an additional 250ms minimum, allowing the power supply and system microprocessor to stabilize. The trip point Also included is a watchdog timer to stop and restart a to...