3-Ch. Diff. Amplifier-comparator
3 CHANNEL DIFFERENTIAL AMPLIFIER-COMPARATOR
(Lower hysteresis version of standard ET9570)
ET9570LH
FEATURES
• • • • • ...
3 CHANNEL DIFFERENTIAL AMPLIFIER-COMPARATOR
(Lower hysteresis version of standard ET9570)
ET9570LH
FEATURES
Supply
Voltage Range 4.5V to 30V Operation to 1MHz Designed for photodiode inputs Index gated by A and B channels Current sink for LED drive (see application note APP-D2) Outputs short circuit protected 25mA peak drive current Comparator hysteresis only 1.1 : 1
APPLICATIONS
High Speed Optical Encoders Industrial Controls
DESCRIPTION
These devices are specifically designed as receiver circuits for the photodiode signals available in optical encoders. Connect the anode of the photodiodes to the input pins, with the cathode(s) connected to Vcc for reverse-bias operation. The input
amplifiers have a dynamic range of nearly 1000:1, and allow contrast ratios of encoded signal to common mode signal of as low as 2:1. Differential inputs enhance noise rejection and performance over temperature. www.DataSheet4U.com Gating of the Z channel provides synchronization of the reference pulse to the data channel phasing. Hysteresis ratio of comparators is 1.1:1, instead of the 1.25:1 on the standard device.
ABSOLUTE MAXIMUM RATINGS
Parameter Operating Temperature Range Supply
Voltage Range Symbol TA VCC Min. -40 4.5 Max. 125 30 Units °C V Ref. Note 1
ETIC RESERVES THE RIGHT TO MAKE CHANGES AT ANY TIME TO IMPROVE THE DESIGN AND TO SUPPLY THE BEST PRODUCT.
© 2000, Rev A1 iC-Haus GmbH Integrated Circuits Am Kuemmerling 18, D-55294 Bodenheim Page 1 of 2 Tel +49-613...