www.DataSheet4U.com
EN25P05
EN25P05
512 Kbit Uniform Sector, Serial Flash Memory
FEATURES
• Single power supply operat...
www.DataSheet4U.com
EN25P05
EN25P05
512 Kbit Uniform Sector, Serial Flash Memory
FEATURES
Single power supply operation - Full
voltage range: 2.7-3.6 volt 512 Kbit Serial Flash - 512 K-bit/64 K-byte/256 pages - 256 bytes per programmable page High performance - 75MHz clock rate Low power consumption - 5 mA typical active current - 1 μA typical power down current Uniform Sector Architecture: - Two 32-Kbyte sectors Software and Hardware Write Protection: - Write Protect all or portion of memory via software - Enable/Disable protection with WP# pin High performance program/erase speed Byte program time: 8µs typical Page program time: 1.5ms typical Sector erase time: 500ms typical Chip erase time: 1 Seconds typical
Minimum 100K endurance cycle Package Options 8 pins SOP 150mil body width 8 contact VDFN All Pb-free packages are RoHS compliant
Commercial and industrial temperature Range
GENERAL DESCRIPTION
The EN25P05 is a 512 K-bit (64K-byte) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction. The EN25P05 is designed to allow either single Sector at a time or full chip erase operation. The EN25P05 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector.
This Data Sheet may be revised by subsequent versions 1 or...