DatasheetsPDF.com

L6362

STMicroelectronics

Fully integrated device transceiver IC - STMicroelectronics


L6362
L6362

PDF File L6362 PDF File



Description
L6362 Fully integrated device transceiver IC Data brief Features ■ ■ ■ ■ ■ Supply voltage from 8 V to 32.
5 V 2 programmable output stages: high-side, lowside or push-pull (< 4 Ω @125 °C) Up to 230 kHz communication speed 2 industrial digital inputs, type 1 compliant and programmable filter Short-circuit and overcurrent outputs protection through current limitation and programmable cut-off current Overvoltage protection (>36 V) 3.
3 V/5 V selectable 50 mA linear regulator (with maximum power dissipation = 200 mW) On chip high efficiency adjustable 50 mA synchronous step-down switching regulator Control, configuration and diagnostic registers Diagnostic dual LED sequence generator and driver Internal clock generator with programmable frequency divider 5 V and 3.
3 V compatible I/Os Integrated active reverse polarity protection with 200 mV @ 200 mA drop Integrated, IEC61000-4-5 surge protection, with source impedance 500 Ω Overtemperature protection ESD protection Conform to IEC 61000-4-4 Miniaturized: QFN 3.
5 x 5 x 1 26 lead package QFN 26L Description The L6362 is a monolithic dual push pull Transceiver fully compliant to PHY2 (3 wires) supporting COM1 (4.
8 kbaud), COM2 (38.
4 kbaud) and COM3 (230.
4 kbaud) modes.
C/Q and I/Q output stages are programmable: high-side, low-side or push-pull; also cut-off current and cutoff current delay time are programmable.
Cut-off current and cut-off current delay time combined with thermal shutdown and automatic re-start protect the device against overload and short circuit.
C/Q and I/Q output stages are able to drive also inductive loads up to 10 mJ.
Supply voltage is monitored and low voltage condition is detected.
L6362 transfers/receives, through the PHY2, data received/transmitted in the digital block from sensor/actuator to/from the L6360 twin device.
To enable full IC control, regarding configuration and monitoring (i.
e.
fault condition stored in the status register) the communication between the system microcontroller and L...



Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)