07 Cracked glass The LCD with extensive crack is not acceptable.
8.1 Illumination source flickers when lit.
8.2 Spots or scratched that appear when lit must be judged.
Using LCD spot, lines and contamination standards.
8.3 Backlight doesn’t light or color wrong.
9.1 Bezel may not have rust, be deformed or have fingerprints,
stains or other contamination.
9.2 Bezel must comply with job specifications.
10.1 COB seal may not have pinholes larger than 0.2mm or
10.2 COB seal surface may not have pinholes through to the IC.
10.3 The height of the COB should not exceed the height
indicated in the assembly diagram.
10.4 There may not be more than 2mm of sealant outside the
seal area on the PCB. And there should be no more than three
10.5 No oxidation or contamination PCB terminals.
10.6 Parts on PCB must be the same as on the production
characteristic chart. There should be no wrong parts, missing
parts or excess parts.
10.7 The jumper on the PCB should conform to the product
10.8 If solder gets on bezel tab pads, LED pad, zebra pad or
screw hold pad, make sure it is smoothed down.
10.9 The Scraping testing standard for Copper Coating of PCB
Y X * Y<=2mm2
11.1 No un-melted solder paste may be present on the PCB.
11.2 No cold solder joints, missing solder connections,
oxidation or icicle.
11.3 No residue or solder balls on PCB.
11.4 No short circuits in components on PCB.
第 18 頁，共 23 頁